Garage Door Springs - Some Safety Concerns
Scott Hares
The springs on your garage door can pose a safety hazard. A
door spring that breaks or shatters can send sharp shrapnel
flying in any direction of the garage. Anyone inside the garage
if that happens is at serious risk of injury.
Modern roll up garage door styles pose little risk in the event
of spring breakage or shattering. These kinds of springs are
installed over a shaft that helps roll the door up to the open
position. The shaft also acts as a retainer so that broken
springs are not allowed to go ballistic.
On the other hand, the flip up style of garage doors can be a
different situation. Old springs are subject to sending
ballistic chinks of steel flying around your garage in the
event of a failure.
These old un-safe springs can be identified quite easily,
because newer springs have a core rod that is retained inside
the coil of the spring. This is a built-in safety feature,
because the core rod will retain any chunks of spring in the
event of breakage. Look at new springs in your local hardware
store. You can easily see the core retaining rod running the
length of the spring.
If your old flip up garage door springs do not include any such
rod, it's best to replace them. But replacing springs can cost
upwards of $100 depending on locality. There is a simple way to
make perfectly good old springs as safe as new ones with some
1/8 inch cable.
Close the door to extend the springs to their maximum position,
and measure the length. Double it and add two feet. For example,
a spring, when extended measures 4.5 feet. Doubled is 9 feet,
and add 2 feet for a total of 11 feet. You will need 11 feet of
cable for each spring. Add one cable clamp per spring to your
shopping list.
Thread the cable up the center of the spring, and back down
outside the spring, forming a loop. Then use the cable clamps
to clamp the ends together. Simple enough, you've just made a
retainer to keep the spring safe should the spring shatter.
If your door uses two springs on each side, add another foot
(12 feet) to the length, and run the cable up the center of one
spring, and down the center of the other - there, you just cut
the cost of this project in half, and your garage is much
safer.
Your best bet is to just replace the springs with modern
self-retaining ones, but this can be difficult and cost upwards
of $100. Adjustments to the door might also be necessary, since
the new springs will have different tension characteristics.
Your garage door opener might not perform as well without
adjustment too. You can always call a professional to replace
springs and make adjustments, but that adds even more to the
cost.
For only a few dollars and some clamps you can make older
springs much safer. It takes only a few minutes, and prevents
what could be a very scary incident should your old springs
break and fly apart.
About The Author: Scott Hares writes for
http://steel-garage-door.com
A free informational resource for
anyone considering a new roll up overhead garage door.
Back to Index of
All Info on Basements, Garages & Roofs
Search our site for any Home, Lawn or Garden Info
