How to choose a Pump
Pumps are available in both submersible and external (out-of-pond
models). Reputable water garden suppliers have charts and other
information available that can help you select the best model and
connecting equipment for your purposes. For the smaller pond, a
submersible pump is the most economical.
Pumps are sized by gallons per hour (GPH) output at one foot of lift
or height. Larger capacity pumps are rated by horsepower (hp).
Manufacturers offer charts that break down the power of each size
pump according to incremental heights of one foot. Some companies
label pumps by GPH while others assign letter or number designations
that require cross-referencing to charts.
To determine the correct submersible pump for your pond, you should
determine your pond's volume. It is recommended that you circulate
your pond's water once at least every two hours. Hence, your pump
should have GPH (gallons per hour) rating of at least half of your
pond size. For example, if you had a 1000 gallon pond, then you will
require a 500 GPH pump.
If you have many fish, or accessories such as fountains, waterfalls,
or streams, you should account for this to be getting a larger pump
(preferably one size larger). The general rule of thumb is that you
should double the pump's capacity if you are planning to add fish.
Calculating the proper pump for waterfalls is a bit trickier,
because waterfall pumps are rated by both GPH and maximum waterfall
height. To estimate your waterfall's height, you must measure the
vertical height from the top of your pump to the top of your
waterfall or stream. In addition, you must add another foot of
height or lift for every ten feet of hosing you will be using (this
will allow for loss of volume from resistance within the hose). To
calculate the required pump GPH, a general rule of thumb is that
each inch of width of the channel will require an extra 100 GPH. For
example, if your stream or waterfall spillway will be 10 inches
wide, you will need a pump that produces an excess flow of 1000 GPH
at your waterfall's height.
Choosing a pump that is too small will result in poor filtration and
surface skimming, excessively long filter cycles and in the case of
a bigger pond, poor action from the circulation jets. You must also
remember that as dirt is removed by the filter, the pressure goes
up, increasing dynamic head and slowing flow rate. Therefore, you
must allow for that increase in pressure when choosing a pump.
Choosing a pump that is too large can result in damage to the
plumbing and equipment. It can also result in cavitation, which can
seriously damage the pump itself. Cavitation is the formation of
bubbles in the water, very near the impeller, that occurs when the
water is intensely vibrated. As the bubbles pop, shock waves are
created within the pump that not only make noise but also burst with
enough force to damage the impeller and other pump parts. Pressures
caused by cavitation have been calculated to be in the range of
30,000 psi!
An oversized pump can also create excessive flow, which can cause
erosion of the system's piping. According to NSF and IAPMO
standards, the flow rate in 1 1/2-inch pipe should never exceed
eight feet per second for copper and ten feet per second for PVC.
So when it comes time to buy a pump, the key factor should be
performance rather than size. Determine the flow requirements of the
system, then consult the pump curves provided by one or more
manufacturers to choose a pump that meets your performance needs.
That way, you'll be replacing the pump truly " the numbers."
Discover the best Pump Information site on the WEB! at
http://www.pumps-inc.com/
See Also:
Index of Swimming Pools and Outdoor Ponds
Search our site for any Home, Lawn or Garden Info
